MotorCodex Español

P0520 — Engine Oil Pressure Sensor Circuit

Moderate

Quick answer

P0520 means the oil pressure sensor's signal is electrically implausible. First move: check the connector at the sensor (oil-soaked connectors are routine here), then test the sensor — but never assume: verify real pressure with a mechanical gauge if there's any doubt.

What it means

P0520 reports that the oil pressure sensor's signal is electrically implausible.

Oil pressure is the engine's blood pressure, and this sensor is the only witness the dashboard has. The golden rule: treat low-pressure readings as TRUE until a mechanical gauge proves the sensor lied. The cost of believing a lying sensor is a new sensor; the cost of ignoring a truthful one is a new engine.

Like every code on this site, the diagnosis below runs cheapest-first — the order exists because the cheap causes really are the common ones.

Common causes

Ordered from most to least likely.

  1. 1.

    See the diagnosis steps

    This family shares its suspect list; the steps below walk it in order of cost and likelihood.

  2. 2.

    Wiring or connector damage

    The universal suspect for any circuit-flavored code.

  3. 3.

    The component named by the code

    Condemned by measurement, never by guess.

How to diagnose it, step by step

Cheapest and most likely checks first.

  1. 1 Check the oil level right now

    Before any electrical theory: dipstick. Low oil causes genuinely low pressure, and that's an emergency the sensor is correctly reporting.

  2. 2 Listen to the engine

    Ticking or knocking that wasn't there before, especially at idle when hot, supports a REAL pressure problem. A quiet, normal engine with a dramatic reading leans toward the sensor — but verify, don't assume.

  3. 3 Verify with a mechanical gauge

    Thread a mechanical gauge into the sensor's port (adapters are cheap; many parts stores rent the kit). Real pressure at spec = replace the sensor and drive happy. Real pressure low = stop running the engine and diagnose (pump, pickup screen, bearings).

  4. 4 Inspect the sensor's circuit

    Connector corrosion and oil wicking into the harness are routine at this sensor's location. An oil-filled connector both fails electrically and leaks — fix the leak too.

Parts & tools you may need

  • OBD-II scanner (code reader with freeze frame / live data)
  • Digital multimeter
  • Replacement component per the diagnosis (sensor, relay, solenoid, pump as found)

Disclosure: some links are affiliate links. If you buy through them, we may earn a commission at no extra cost to you.

Related codes

Frequently asked questions

What does P0520 mean in plain words?
The oil pressure sensor's signal is electrically implausible. Check the connector at the sensor (oil-soaked connectors are routine here), then test the sensor — but never assume: verify real pressure with a mechanical gauge if there's any doubt.
My oil light flickers at idle but the engine sounds fine. Sensor?
Maybe — or marginal pressure from a worn pump/bearings showing up exactly where pressure is lowest (hot idle). This precise symptom is why the mechanical-gauge test exists. Do it before dismissing the light.
Can I drive to the shop?
With a LOW pressure reading: ideally no — tow it or verify with a gauge first. With a stuck-high/circuit code and a quiet engine: short careful drives are reasonable while you arrange the fix.